GS3 not working after rewire ?

[lkthomas]

hey all, let me explain what I did:
1. run GS3 orchestra
2. load old gigapinao I sample into GS3
3. try to port Mia MIDI input to Gigaport1
4. press keyboard, work fine ( nice sound too )
5. I didn't unload that piano sample, then unmap port of input to none.
6. run cubase sx2 in same time
7. create a midi track
8. change the input and output section to Mia MIDI, Gigaport1 channel 1.
9. press keyboard
10. NO SOUND!!

anyone have idea ?
also, how come ECHO MIAMIDI driver are GSIF1.70 not 2.0 ?!
Thanks.

[TobyBrez]

hey all, let me explain what I did:
1. run GS3 orchestra
2. load old gigapinao I sample into GS3
3. try to port Mia MIDI input to Gigaport1
4. press keyboard, work fine ( nice sound too )
5. I didn't unload that piano sample, then unmap port of input to none.
6. run cubase sx2 in same time
7. create a midi track
8. change the input and output section to Mia MIDI, Gigaport1 channel 1.
9. press keyboard
10. NO SOUND!!

anyone have idea ?
also, how come ECHO MIAMIDI driver are GSIF1.70 not 2.0 ?!
Thanks.

Hey lkthomas,

I've had a similar experience to what you describe although I'm using SONAR and Giga Rewired.
Have you tried stopping and restarting the audio engine in Giga?

When you press a note on your controller keyboard, watch the midi numbers at the bottom of the Giga UI. Do any of the midi numbers flash red?

Also, I don't believe Echo have developed any GSIF 2.0 drivers yet.
Hopefully soon, I have a Layla.

May be a place to start, I hope this helps.

Toby
http://www.soundclick.com/bands/4/tobybrezmusic.htm