Increasing memory load in GS3?

[Herman Witkam]

I used to get to 93% in GS2.5....but now runnig GS3 I simply can't pass 57%. I've tried various memory tweaking options, but they haven't resulted in a higher percentage. Any tips on this one?

[yeehaanow]

There are a couple posts about this, with a registry tweak tool that can help you if you have over 1GB of RAM. Do a search and you'll find it.

[Bill]

I have the same thing.

If you find the link, can you re-post it? I just haven't had time to sort through all the posts.

[Herman Witkam]

If you're referring to "the" tweak....I've done that one. It did help for me in GS2, but GS3 doesn't seem to profit from it.

[mal7]

check this thread on VSL forum

http://vsl.co.at/forum/viewtopic.php?t=934&sid=cebb5cd1f4ef69996898003f714e1e8f

[Mattias Henningson]

The memory counter value in GS3 gives completely different values from the one in 2.5. On my 1.5 GB machines 99% in Giga 2.5 was about 800MB load on the msg32.exe process, but in GS3 the same 800MB corresponds to 70%. It may seem a bit confusing, but they needed to change it to give room for the higher memory load in GS3.

/Mattias

[Herman Witkam]

Ok thx. That's an explaination. I couldn't compare it myself, since I would have to reinstall over again.