nfx in all channels?

[map]

hi list,
this is a newbie question, sorry about that. i can\'t find how to put reverb (or any nfx) to *some* channels only. is it possible? all of my loaded gigs go through those nfx, either in inputs or aux busses. i can\'t find how to put nfx\'s on selected channels only.
thx in advance for any help,
map

[Sapkiller]

Hi map
The DSP station is just like any mixer - the effects applied to a mixer channel will effect
all the input on that channel. You insert effects
at the top of the DSP mixer ch, say ch 1-2 where
it says \'Empty\' - just click it.

Then you have to route the midi channels to the
DSP channels. This is done at the Midi mixer for each port 1-4. At the bottom of each midi channel
there\'s a designation of a DSP channel.
All midi channels set to say 1-2 will now be
routed to the DSP ch 1-2 and thus have the effects
applied.

Hope this helps you out.

regards
Bjarne

[map]

thanks for your help bjarne. i can only get more than 2 mixer inputs if i use my multitrack soundcard, a ews88. if i use my tbs pinnacle i get only 2 mixer inputs. so i think i have to rework my question. is it possible to assign different nfx\'s to different midi channels with a stereo soundcard? let say reverb in channel 1 and delay to channel 2, is that possible?
thx again,
m.