Balhauer
08-25-2003, 06:24 AM
Hi, friends:
I\'m new to Gigastudio and desktop audio recording. I\'ve been doing my homework and reading a lot trying to figure out how to configure Gigastudio and Cubase SX to work on my machine (Pentium III 700, 256 RAM, Win2K).
I have been able to sort out a lot of \"problems\", but there is this one I haven\'t:
Whenever I \"capture to wave\" from Gigastudio, the level (volume) of the resulting wav file is extremelly low. I have a Delta 1010LT and I\'ve tried to lower the input value to Consumer and even -10Db, but it seems to make no difference in the incoming signal level.
Is there any output level setting in Gigastudio that one can adjust? When I open the file in Cubase SX the waveform barely shows (almost a flat-liner). What am I doing wrong?
Thanks a lot
Balhaüer
I\'m new to Gigastudio and desktop audio recording. I\'ve been doing my homework and reading a lot trying to figure out how to configure Gigastudio and Cubase SX to work on my machine (Pentium III 700, 256 RAM, Win2K).
I have been able to sort out a lot of \"problems\", but there is this one I haven\'t:
Whenever I \"capture to wave\" from Gigastudio, the level (volume) of the resulting wav file is extremelly low. I have a Delta 1010LT and I\'ve tried to lower the input value to Consumer and even -10Db, but it seems to make no difference in the incoming signal level.
Is there any output level setting in Gigastudio that one can adjust? When I open the file in Cubase SX the waveform barely shows (almost a flat-liner). What am I doing wrong?
Thanks a lot
Balhaüer