MOL port 2 - help!

[Marcussen]

Every time I load GS3 I ahve to go into the settings menu and tell it to use the input from MOL but only on port 2. Port 3 and 4 are saved every time, and I dont have to set them up. But port 2 is always just blank - regardless of whether I choose "apply" or just "ok". It works though, just annoying I have to go in and do that setup every time I restart GS3...

Any ideas? Does my problem make sense? I find it quite hard to describe

[JonFairhurst]

I'd recommend looking at your MOL settings with a fine toothed comb. There's probably one odd item, like a name that was already used, or a strange filter setting.

Make sure to reboot after making and MOL change, and double-checking that it really stuck.

Good luck!

-JF

[Marcussen]

Trying - cant really locate the problem :-/

[tonylombardi]

I had some problems with MOL, the new one, before. Can't remember exactly what I did, but this might be it - If it's really screwy, try uninstalling and deleting all the MOL stuff in the windows registry. The uninstall might not delete it. Then reinstall.