Midiman Audiophile 2496

[Viktor]

Anyone here with some experiences with this card? Seems like a good solution for ones who doesnt need many inputs and outputs and still need MIDI interface. These days we can hopefully expect multiclient asio drivers according to Midiman.

[midiot]

I am using this card in a two computer system.

Computer #1 is running Cakewalk Pro Audio 9.03 w/ a MOTU 2408MK-II and Gigastudio.

Computer #2 is running Gigastudio w/ the Audiophile card......it sounds great! No installation problems.......highly recommended......no noticeable latency!!!

[Viktor]

Card is not multiclient, isnt it?
Can you access the card by gigastudio and cakewalk at the same time?

Thanks alot

What about latency in cakewalk?

[Laki]

<BLOCKQUOTE><font size=\"1\" face=\"Verdana, Arial\">quote:</font><HR>Originally posted by midiot:
I am using this card in a two computer system.

Computer #1 is running Cakewalk Pro Audio 9.03 w/ a MOTU 2408MK-II and Gigastudio.

Computer #2 is running Gigastudio w/ the Audiophile card......it sounds great! No installation problems.......highly recommended......no noticeable latency!!!<HR></BLOCKQUOTE>

Hi, I am using the Audiophile Card too.When I installed it first,Gigasampler never got a MIDI Message.Then Iuninstalled it andreinstalled it together with Cubase3.7 But after starting Gigasampler my whole System crashes down.Now, although I uninstal Gigasampler it will always crash down my System after reinstalling.

If you have suggestion where the Problem may lie Please answer

[rrob]

Just put the card into the computer. It works well except that I cannot configue gigasampler to use 48khz sample rate, it just does\'nt show up in the configuration page only 44.1. Does anyone have a solution?


------------------

[TEMPS]

Forgive me if you know this already, but...

Have you gone into the Delta Control Panel and made sure that it is not locked to any particular sample rate? Also, make sure that it is not set to \"reset when idle\" Other than that I\'m really not sure what would cause that problem. Once these two things are done you should be able to control the sample rate from gigastudio.