GigaStudio not seeting Pulsar's Midi "in"

[kirk]

Hi all...

just moved GigaStudio off the sequencing computer to a freshly built machine...but GSt doesn\'t see the the keyboard\'s midi-in data when the keyboard is attached to Pulsar 1 or 2\'s midi \"in\" ports...

GSt only sees the SoundBlaster midi-in when the keyboard is connected to it...

Any tricks to getting GSt to recognize the Pulsar midi in\'s?? (BTW, GSt\'s \"hardware config\" shows the Pulsar midi \"in\'s\" which I have selected in that menu, when I\'m testing and GSt\'s keyboard and 1-2-3-4 port boxes, still don\'t light up red...?

thx in advance for help...

Kirk

[LHong]

Make sure that in the Pulsar project, you have the \"MIDI Source Out\" be connected to the \"Sequencer MIDI Dest(x) In\", where x is 1,2,3 or 4. That\'s all.
Ex: MIDI Source Out -> Sequencer MIDI Dest1

BTW, You might need to re-launch the Giga. In the Giga setting and Hardware-Routing, you also need to enable MIDI-IN as well, don\'t forget to click APPLY.


[This message has been edited by LHong (edited 01-18-2002).]

[kirk]

Thx LHong:

Of course, I missed connecting to \"Sequence Midi destination\" (really dumb)

although I had this connection for years already when Logic was on the same \'puter, now that I\'ve moved Puslar to a separate new 1.8 CPU etc..., it never occurred to me that GigaSt is a \"sequencer\" for this purpose...

of course, that\'s all from Pulsar\'s viewpoint...

So thx...you saved me USDx00 bucks on NOT buying a new midi in/out device for the new \'puter...


Kirk