Reverse cut-off by Modulation?

[Simon Ravn]

Hi!

I was wondering. How can I do a \'reverse\' cutoff change by using e.g. the mod wheel? So that if I apply a low freq. filter to the wheel, I\'ll get a LOWER cutoff as I push the wheel, rather than OPENING the frequency? I need this for brass sounds, and I want the default to be a fully open cutoff, but being able to close the frequencies by pushing the wheel - is this possible???

Simon

[Sam]

Not really possible as far as I can tell. Not a lot of flexibility in the modulation dept. You could fake it pretty well by using like 16 dimentions for filter cutoff, mapped \'upside down\' and modulated with the wheel.

-s