• Register
  • Help
Results 1 to 4 of 4

Topic: Single note will not sound using Cubase 3sx and GPO 2

Share/Bookmark
  1. #1

    Post Single note will not sound using Cubase 3sx and GPO 2

    I just (that's a lie...I've been trying to figure out the problem for the last 15 minutes ) input a note (B') in Cubase with my mouse but there is no sound. It is within the sound range of the instrument - a viola in this case - and the velocity reads 88 and the Mod is at 127. Changing velocity or mod makes no difference. If I use the arrow keys and nudge the note up or down 1 semitone, the sound is there in all its glory (ok, I know 'glory' is pretty subjective). Does anyone have any ideas what is happening? Thanks in advance for any help you might provide. What's left of the hair on my head will thank you too!

  2. #2

    Re: Single note will not sound using Cubase 3sx and GPO 2

    Try reloading the patch in Kontakt?

  3. #3

    Re: Single note will not sound using Cubase 3sx and GPO 2

    Hi Reegs,
    Thanks for your help. I guess I should have mentioned in my original posting that I had tried reloading the patch in Kontakt, restarting all the software, and rebooting my computer. So far no luck.
    Thanks again,
    George

  4. #4

    Re: Single note will not sound using Cubase 3sx and GPO 2

    Alright then. Which patch is it, and which note?

Go Back to forum

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •